|Я не говоpю по-pусски - свобода Украине ! We do not speak russian - free Ukraine !||CHF CZK EUR GBP NOK USD|
Thank you for your interest in this latex vacbed . You will have lots of fun with it. However , there are some rules , which need to be adhered to in order to operate it safely . We have prepared few tips for you . Please read them before you use the vacbed .
SAFETY FIRST :
never use this type of vacbed alone . It is very strong bondage device and you may not be able to get out without help from outside , if anything goes wrong . Before turning the vacuumcleaner ON , ask for permission from the person inside . For case of emergency , establish “stop-signal” with your partner . This signal should be non-verbal , if you have vacbed , where the head is inside . Whenever this signal is used , partner on outside should immediately release the vacuum and help you to get out . “Stop signal” must NEVER be ignored . When you are watching over somebody in vacbed , never leave him alone , never let him out of sight and always stay within few metres of the vacbed , so you can intervene in case of need .
Firstly , assemble the frame according to the scheme . Then pull the latex sack over the frame - firstly pull the sack and the short sleeve over the valve , then continue with rest of the vacbed . The sleeve should be smooth around the valve , free of any wrinkles - thru them air may penetrate into the vacbed . It helps to lubricate the inside with latex polish ( do not use talc on inside of vacbed - it may cause valve malfunction) .
Using the aluminium rod , roll up excess length of the vacbed . Take care to roll it up tightly and without any wrinkles , which may cause air leakage . Then , secure the seal with supplied clamps . Make sure to use thick stripes of latex to underlay under the clamps - this is to protect latex sack from any possible damage by clamps .
AIR EVACUATION :
Attach vacumcleaner to the vacbed . Ask the person inside for permission to turn it on . Only then turn the vacuumcleaner on . When the air is completely evacuated , disconnect the vacuumcleaner from vacbed and then turn it off . If you turn the vacuumcleaner off , while still conneced to vacbed , some air may get back into the vacbed , because for proper function , the valve needs sudden pressure change .
RELEASING VACUUM :
Simply roll out the seal of the vacbed and separate layers of latex . Vacbed will instantly inflate .
After each use , wash the vacbed with soap and water ( both inside and outside ) . Then let it dry on dark and cool place . After it dries on one side , turn it inside out , so both sides can dry .
IF THE VACBED DOESN´T HOLD VACUUM
If the vacbed holds vacuum for no more than five minutes or so , you need to find the leak . In most cases , the rolled-up entry is to blame . Make sure , that there are absolutely no wrinkles and that it is rolled up tightly . Lubricating it with silicone also may help . If this doesn´t help , check the valve : dip about 2 cm of the narrow end of the valve in the water and try blowing into it from other side . There must be no bubbles coming out of it . If bubbles do come out , try running some water thru it , let it dry completely and then put few drops of silicone oil into it ( from the narrow side ) . Then test it again .
If you have any problems whatsoever and you don´t find answer in this manual , please feel free to ask questions .
We wish you many pleasant moments with our latex vacbed
|Don´t forget to add to your order : talc ( makes dressing up easier ) - and latex polish ( enhances natural gloss of latex )|
Latex polish & lube