Stand-up vacuum bondage in airtight latex tower ! As with all of our vacuum products , this one is also airtight - so you can disconnect the vacuum cleaner and enjoy the bondage without noise of running vacuum cleaner .
The tower will be made-to-measure according to your height . After you order , send following measurements by email :
- distance from ground to base of your neck ( height below neck ) ... or your total height ( height above-head )
- neck circumference
- if mask is attached , then mask measurements ( see mask product page for list of measurements )
The tower comes with stainless steel frame and with airtight one-way valve as standard .
Standard size of the tower is 60cm ( width ) x 50 cm ( depth ) x height made to measure .
The tower is available in three heights :
- height below neck ( tower height up to 160cm ) : head is then outside - either with made to measure airtight collar or with airtight-attached mask ( with mask , side entry mandatory . The mask itself has lots of options available ) .
- above-head , height 160-180 cm : head is then inside . You can have variety of gags attached or half mask . Side entry is mandatory .
- above-head , height over 180 cm : head is then inside . You can have variety of gags attached or half mask . Side entry is mandatory .
In conjunction with some options , side entry is mandatory ( attached full-face mask , heigth above-head ) . Without side entry , you dont need to operate the roll-up entry to seal the tower .
WARNING : the frame needs to be assembled inside the tower piece by piece . Without side entry , you have only the collar available for that. Although it can be done , lot of patience is required .